Toni's NEW RZR-4 Robby Gordon but I get to drive it

[DUNE DUMMY 29]

The only spec I found on them is

[FONT=&quot]20 Amp (240 watts). Illuminates when "on". Use .250" disconnect terminals. Drill 1/2" hole or use with panel 85925[/FONT]

[FONT=&quot]and[/FONT]

[FONT=&quot]20 Amp (240 watts). Switch with aircraft safety guard: lift cover and flip switch to turn on, flip down cover for quick off. Perfect master "arming" switch for ignition, nitrous, etc.[/FONT]

I HAD THE BLUE ILLUMINATED SWITCHES ON MY GOLFCART. THEY ARE IN AN AREA WHERE YOU BUMP THEM WITH THE BACK OF YOUR LEG. I KEPT BREAKING THEM OFF. I HAVE THE COVERED TOGGLE SWITCHES IN THE DASH OF THE RHINO. I LIKE THEM BUT I HAVE BURNT OUT SEVERAL SETS OF THEM. I AM NOT SURE IF IT IS FROM THE DUST OR FROM WASHING THE RHINO. I LIKE THE COVERED TOGGLES THE BEST.

 

[DUNE DUMMY 29]

ON A DIFFERENT SUBJECT BUT IT COULD HELP YOU OUT TOO ERNESTO. HOW DO YOU KEEP DUST & WATER OUT OF THE BACK OF YOUR RACE RADIO? I WASH MY RHINO A LOT BECAUSE WE USUALLY RIDE IN VERY DUSTY AREAS & WE ARE USUALLY @ THE BACK OF THE PACK. (BY CHOICE)

 

[Class51600]

1 Internal lights (Switch)

2 Rear light (Switch)

3 Intercom


(Possible switch even though it has a power on off)


4 Radio


(Possible switch even though it has a power on off)

5 Open

6 Open




#1 Race radio and intercom (Pictures of what other people have done for example how they routed the wires and so on) Working on it almost done, thank to E3 and the pics of George's rig.
#2 Mount for race radio antenna (On order)
#3 Rear view mirror and mounts (On order)
#4 Mount for green sticker (On order)
#5 Mount for Flag
#6 Mount for extra tire
#7 Mount LED lights in the cab for night riding.
(I have LED's that I was planning to used for signals on the old rig)
#8 Rear LED dust light
(I have LED's that I was planning to used for signals on the old rig)
#9 Mount for ice chest
#10 Mount for gas tank
#11 Front LED or HID lights for night riding.

 

[Class51600]

Is it for + or - connections ?

the lights are LED one connector only. No ground not sure why. They are the lights Papa recomended for turning lights.

 

[Class51600]

ON A DIFFERENT SUBJECT BUT IT COULD HELP YOU OUT TOO ERNESTO. HOW DO YOU KEEP DUST & WATER OUT OF THE BACK OF YOUR RACE RADIO? I WASH MY RHINO A LOT BECAUSE WE USUALLY RIDE IN VERY DUSTY AREAS & WE ARE USUALLY @ THE BACK OF THE PACK. (BY CHOICE)

Remove it or cover it with plastic bags. I plan on covering it because I mounted it on my roof and should be a bit less dust on it.

 

[Cisco Kid]

the lights are LED one connector only. No ground not sure why. They are the lights Papa recomended for turning lights.

If you have + on the myou will need a water proof cover ;-)

 

[Class51600]

Do you have any suggestions? How are you connecting all your stuff to the battery directly?

 

[Cisco Kid]

Remove it or cover it with plastic bags. I plan on covering it because I mounted it on my roof and should be a bit less dust on it.

That is the same place we just installed mine, it looks and works better for me ;-)

and I hope it will have NO dust or water problem ;-)

 

[Cisco Kid]

Do you have any suggestions? How are you connecting all your stuff to the battery directly?

I just order this one
One + connection to the Battery and all the fuses in one location and coverd ;-)

Fuse Blocks and Fuse Panels
6 Circuit Raised Ganged ATO/

ATC Fuse Block

 

[DUNE DUMMY 29]

That is the same place we just installed mine, it looks and works better for me ;-)

and I hope it will have NO dust or water problem ;-)

MINE IS IN THE DASH. I CARRY A PLASTIC TRASH BAG ON RIDES IN CASE IT RAINS. WHEN I WASH THE RHINO I AM CAREFUL NOT TO GET THE BACK OF THE RADIO WET. IF YOU KEEP IT COVERED WITH A PLASTIC BAG WHEN YOU RIDE, WON'T THAT KEEP THE HEAT IN?

 

[Class51600]

MINE IS IN THE DASH. I CARRY A PLASTIC TRASH BAG ON RIDES IN CASE IT RAINS. WHEN I WASH THE RHINO I AM CAREFUL NOT TO GET THE BACK OF THE RADIO WET. IF YOU KEEP IT COVERED WITH A PLASTIC BAG WHEN YOU RIDE, WON'T THAT KEEP THE HEAT IN?

I only meant for washing not riding, they tend to get very hot.

 

[Class51600]

Look at this 5 for under 20 dollars.

[ame=http://www.amazon.com/Ancor-555105-Marine-Electrical-Waterproof/dp/B000NI1HOW/ref=sr_1_2?ie=UTF8&s=sporting-goods&qid=1304451800&sr=8-2]Amazon.com: Ancor 555105 Marine Grade Electrical Nickel Plated Brass Toggle Switch Waterproof Toggle Boot (5-Pack): Sports & Outdoors[/ame]

 

[JimandMelissa]

Look at this 5 for under 20 dollars.

Amazon.com: Ancor 555105 Marine Grade Electrical Nickel Plated Brass Toggle Switch Waterproof Toggle Boot (5-Pack): Sports & Outdoors

Read the fine print - That's for the boots only......

 

[Class51600]

Yea I know the problem was that most around here were between 7.99 and 13.99 so I thought it was a good idea if I need some more and just thought of a few.
interior light
rear light
front LED
flag light

 

[RZRluvr]

Hey Ernesto,
Could'nt find the link to the dome lights I have but found some that were similar
Surface Mount LED Light - Machined Aluminum - 10-30Volts - 90mA draw - Courtesy or Down Light - www.MagnaLight.com Spotlights and Flashlights

George

 

[Class51600]

Thanks Jorge... Hey you were going to post the LED's for your trailer can you do that please.

 

[RZRluvr]

Here ya go BigBoy,
These are the ones I have. They are $6.00 for a pair and work great!
194 168 501 921 License plate WEDGE 15 LED BULBS WHITE | eBay
Those are the ones for the inside. The ones I put in the floodlights out side are these.
http://cgi.ebay.com/ebaymotors/LED-...ptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories

 

[Class51600]

Question, what size fuse are you guys using for the LED light? I see 5 and 3 amp. Any suggestions? Not part numbers just amperage.

Thank you.


By the way I'm still working on wiring but it's looking real good, I have 4 switches 3 installed, I need to add one more tonight. I connected the switch on the ground side based on one of my electrician's friend suggestion. So it looks real good I will post pics when I complete it.

1 Inside LED
2 Rear dust LED
3 Future flag LED light
4 Future front LED lights

 

[Class51600]

By the way the by the ground side I mean this:

LIGHT RED to BATTERY RED
LIGHT BLACK to switch then switch to BATTERY BLACK.

I have tested and it works well, anyone see any issues?

 

[Cisco Kid]

Put the RED / Power / fuse to the switch 1st ;-)