bit the bullet and bought the STM clutches

[megadesertdiesel]

after blowing up three $180 CanAm belts, and my secondary clutch bolt comming loose 2 seperate times i finally said screw it and ordered up a STM Rage 6 and STM secondary through //Airdam clutches. I spent some time on the phone with Adam explainning on how i drive and told him i wanted a bullet proof setup.

I got the Rage 6 with steel spider and tuner secondary. I sure hope this fixes all of my clutch issues, because it was not cheap to buy.

off to Glamis tomorrow.

first ride around the block was ok, i put a new belt on it so i was fairly easy on it. The clutch is butter smooth and no noise from it at all.

i used valve lapping compound to set the tolerance tight.

 

[fastjesse]

Did you get around to doing those 0-60 tests before you swapped everything out?

 

[warlock]

What weight Arms and Helix and springs you go with.

 

[megadesertdiesel]

Did you get around to doing those 0-60 tests before you swapped everything out?

no, my stock tires are so out of balance. At 60 mph it felt like the car was going to shake apart. I really wanted that data too.

 

[megadesertdiesel]

What weight Arms and Helix and springs you go with.

rage 6
steel spider
PATV9 gold primary spring
40 gram base 07 40AX
weight setup 7-3-0-2


tuner secondary
40 degree helix
2 shims
PS-13 Gold spring