All UTV's Were do i get my powder coat off???

[Austin Kimbrell]

my panels???

a paint stripping place??

any body know were to get this done??

 

[Mopar]

usually anywhere that does P/C will also be able do blast it off.... but if youve got aluminum panels they cant be blasted without the aluminum pitting, so i dunno

 

[Austin Kimbrell]

yea i have aluminum any one? haha

 

[Bad@$$Teryx]

I just did my cage. They guys at Glendale Powdercoating told me burn it off with a torch. I took their advice and did it...I should of just paid them the $150 to do it. What a chore

 

[Austin Kimbrell]

so will do aluminum for 150?

 

[Bad@$$Teryx]

Call them

 

[facteryfmf]

Ill bet youre better off having new panels built....

 

[KJSmith84]

fusion powder told me that they use a chemical stripping slovant for alum. panels. cost alittle more but they could do it.

 

[Cheek]

i do powder coating, u need to find a salt stripper. they put the parts in a vat and it eats it off. it looks new when done.

 

[s2k1]

Aircraft paint remover. You can buy it at Automotive paint supply stores. Usually comes in 1 gallon containers. Often, powdercoat shops offer this service.
Do NOT let anyone blast your panels. They are too thin and will warp badly from the heat generated from mechanical stripping.

 

[KJSmith84]

yep Aircraft paint remover works too. I have done this to several street bike rims to then polish them up. not to expensive either- just time consuming.

 

[trunknuts]

I'm in the powder coating industry also. Easiest way to do it at home is industrial paint stripper and pressure washer. Make sure to wear gloves and safety glasses. You can pick up the stripper at most paint supply stores including automotive paint vendors. Good luck.

 

[mdbann5800]

Aircraft paint remover. You can buy it at Automotive paint supply stores. Usually comes in 1 gallon containers. Often, powdercoat shops offer this service.
Do NOT let anyone blast your panels. They are too thin and will warp badly from the heat generated from mechanical stripping.

what he said. i do powdercoating. the best stripper is made by a company named. dads. a little time cunsuming but works. keep it out of the wind, it need to stay wet as long as possible, but dont keep respraying it to keep it wet. u cant burn it off because it aluminum, if it was steel i would say burn it off.

 

[Zerofield]

just go find a stripper, facterfmf knows a lot of them in your area.