Recent content by Kustomfab2003

Couple of more from today. Front bulkhead is going in, Pro-Am steering rack and more of the bracing. Picked up the Hellion hood from Wild Earp and got it up there. We will be adding to it to make it work as the midrail on this is 66" wide :eek:

PM sent... sounds like a perfect fit!

VERY NICE!!!! What shifter are you using? I would like to ditch the stock setup and get one like that.

I mostly need it wider where it mouts towards the A Pillar. The empyre is still set up to use the stock style dash insert so it narrows up quite a bit up front. What type of price are you looking at for the Hellion? I found a Frod Ranger one piece clip that would possibly work as well....

WOW!!!! That looks great! Nice way to set it off. Did they roll that or stamp it?

I work for ESAB and was in the ESAB booth accross from the main Praxair tent.

I am going to need a wider hood then the Empyre I have... JoeyD any ideas? My chassis is about 60" wide at the A-pillar and would like something just as wide.

A few more pictures... been out of town at the World AG Expo the last week... Hopefully more to show next week.

Basic skeleton started... going to need a wider and deeper hood. Changing the front to a J Arm instead of a A-Arm top and bottom. Will post more over the weekend as progress continues...Wheels are set at full bump with 5" of clearance under the chassis.

Looking good, keep the progress pic's and updates coming.

Desert mostly. Johnson Valley, Ocotillo etc...

Ben is correct, not a race car... a 4 seat car for my kids and I to romp around the desert in. If I were to build a racer, I would stay within spec's. I just wanted to have a unique 4 seater that was not on the market. This would have been out about 6 months ago, but the builder and I got behind...

Here are some teaser pic's of my version of a 4 seat Rhino with a 2006 R1 engine. This will be much like a RZR4 but with about 20" wheel travel on all sides etc. 109" Wheel base x 76" wide track width front and rear Class 10 bulkhead and front arms scaled down for width with 1" uniballs top...

Looking good, hopefully you can see it through to completion!:)

What gearing did you end up with front and rear? I too am building a custom R1 powered scoot and will be turning a 15" wheel with a 28" BFG KM2.